Due to the limited space available for drilling, i used an extended #40 drill bit as shown here.
posted by Unknown at 8:41 AM
Tuesday, October 14, 2008
Previous Posts
- I assembled the aileron bellcrank as per manual an...
- The nose ribs' rivet holes at station 69 and 144.9...
- Here , i took out the whole leading edge assembly ...
- Another proof that i was there.
- Once again , main ribs at station 69 and 141.75 ar...
- Another job well done.
- I am seen drilling both the forward and aft spar r...
- Close up view of the lower stringer channels in p...
- With the lower centre skin placed into position, i...
- With the lower centre skin placed into position, i...
0 Comments:
Post a Comment
<< Home