With the centre and inboard leading edge clecoed and clamped properly, the rivet holes are drilled .
posted by Unknown at 6:00 AM
Monday, September 19, 2011
With the centre and inboard leading edge clecoed and clamped properly, the rivet holes are drilled .
Previous Posts
- With a week off early Sept 2011, i continued on wi...
- My 9M-TNC !!!
- With all drilled up , i clecoed the leading edge...
- Meticulously measuring both bottom and top nose ...
- Spot my new green compressor tubing!!!
- Alignment issue solved
- 25 Nov 2009 :I flipped over the wing to align the ...
- View of all the leading edges drilled to the forwa...
- Followed by of course the inboard leading edge...
- Next, the centre leading edge was drilled.
0 Comments:
Post a Comment
<< Home