Meticulously measuring both bottom and top nose leading edge, i drilled with a long L shaped beam clecoed for good alignment.
posted by Unknown at 10:08 AM
Tuesday, August 23, 2011
Meticulously measuring both bottom and top nose leading edge, i drilled with a long L shaped beam clecoed for good alignment.
Previous Posts
- Spot my new green compressor tubing!!!
- Alignment issue solved
- 25 Nov 2009 :I flipped over the wing to align the ...
- View of all the leading edges drilled to the forwa...
- Followed by of course the inboard leading edge...
- Next, the centre leading edge was drilled.
- Close up view of me drilling as a proof.
- A top view of the outboard leading edge after a fe...
- First of all, my deepest apology for not updating ...
- Sidetracking, i found the animation below very int...
0 Comments:
Post a Comment
<< Home