Drilling in process using my dre
mel tool.
mel tool.
posted by Unknown at 1:56 AM
Monday, September 10, 2007
Previous Posts
- Nine #30 bit holes were drilled .
- Upper aileron bellcrank bracket clecoed to upper a...
- Complete set of aileron bellcranks.
- Another set of bellcrank was being drilled.
- Clse up view after drilling the center bearing. Ex...
- Next up was the assembling of the aileron bellcra...
- Now that the alignment is acceptable to standard, ...
- Inboard rear spar . Confirm 0.1 . Check!
- Inboard front spar . Confirm 0.1.Check!
- Centre front spar. Confirm 0.1. Check!
0 Comments:
Post a Comment
<< Home